ONE FOR TWO

January 04, 2023

Ohlsdorf, Austria

MultiTherm® replaces existing machines.

When metalworking companies work much more productively with a few new machines than with several old ones, it is always something special. Jacquet Metallservice GmbH in Ohlsdorf, for example, is delighted about a new level of productivity with the MultiTherm® from Messer Cutting Systems.

Getting better

The two old plasma cutting machines could no longer cope with Jacquet’s increased requirements. “In order to further expand our market leadership, we set ourselves the goal of improving quality, significantly increasing our efficiency, and optimizing our services,” explains engineer Walter Petermeier, Managing Director and Project Manager at Jacquet Metallservice. “We also wanted to greatly reduce our response time by maximizing machine utilization with minimal downtime,” adds Markus Reitinger, the company’s workshop manager.

Therefore, it was important to find a productive system that would replace the two existing machines with one machine without a major loss of production. In times of pandemic and the difficulties caused by interruptions in the supply chain, this was not an easy task.

Support in the selection of the machine came from the German colleagues in Bochum, Ohlsdorf’s sister company. They already had a machine from Messer Cutting Systems in operation and were enthusiastic about price and quality.

Quick decision

The contact with Gerald Wimmer, manager, and Head of Messer Cutting Systems Austria, was quickly established agreement was reached in no time: Jacquet decided on a MultiTherm® with a working area of three meters wide and twelve meters long. The machine is completed by a Hypertherm HPR 800XD and a water table from Beuting. “We cut stainless steel up to one hundred and fifty millimetres thick with plasma under water, with nitrogen (N) and argon-hydrogen (H35),” Reitinger explains.

Whether plasma (vertical or bevel), multi-torch oxyfuel cutting, laser (vertical or bevel), marking, drilling, or a combination of all the above processes: The MultiTherm® designed for a wide range of applications thanks to its variety of equipment options. High-performance drives for speeds up to 50 m/min enable a high positioning speed. Optimum cutting speeds are achieved even with fine contours. Sufficient parking space for the units above the wheel housings ensures optimum use of the effective working width. Of course, the multi-torch operation is possible in oxyfuel as well as in plasma mode and ensures high productivity.

A bulkhead wall was installed on the table at Jacquet Metalltechnik. This wall makes it possible to divide the table into two areas. This reduces the standstill sides when removing components.

Fast implementation

Thanks to the exact preliminary planning of the project partners, the implementation was just as quick as the decision in favour of MultiTherm®. The high level of competence on both sides was a guarantee for the very short installation time: “Messer Cutting Systems handled everything thoroughly. The installation team worked excellently with our team and so we were able to dismantle the old machines and install the new ones in a very short time. We only had a very short downtime and were quickly able to resume our normal production,” Reitinger and his workshop team are pleased to report.

“We are very satisfied with the system and the extremely good cuts,” Petermaier sums up.

Messer Cutting Systems, GmBH

MultiTherm® in use at JACQUET Metallservice